Gamma 6004 manual

Also See for Owner's manual - 20 pages Owner's manual - 24 pages Owner's manual - 20 pages. Table Of Contents.

Quick Links Download this manual. Table of Contents. Previous Page. Next Page. Gamma Owner's Manual 20 pages. Page 2: Table Of Contents 5 years from the date of original purchase for mechanical parts excluding string clamps , and for a period of one 1 year from the date of purchase for string clamps. Manual Spring Tensioner! Diamond Coated String Gripper! Tension Range: 11lbs. Full Degree Turntable Rotation!

Precision Bearing Mounted Turntable! Large Convenient sq. The legs must be assembled to the support post before use. Remove the lower column support from the carton. Align the holes in the leg flange with the matching holes in the lower column support post. Place the bellows section with the flange over the upper support column with the flange on the top. Place the remaining bellows over the upper support column and mate it with the flange on the lower bellows.

Attach the turntable to the turntable pin flange using the included 4 - M6 cap screws. Tighten securely. Frame Support Post Installation The support post assemblies are precision aligned at the factory and are marked for proper installation on the turntable. Remove any excessive grease with a clean cloth prior to use. The post and tube may also be cleaned with isopropyl alcohol.

Page 8 Travel Stop Setting the Gripper Jaw Spacing The gripper jaws of the tensioner are adjustable to accomodate varying string gauges. The tools you will need to assemble the machine are provided with the machine. Page 5: Assembly Instructions The legs must be assembled to the lower column support before use.

Secure them with the included hex wrench. String Clamp Installation The post of the string clamp and tube of the string clamp base are treated with grease to To adjust, loosen the two set screws on the lower column support post below the bellows assembly. Adjust the amount of engagement between the upper and lower column supports until the desired height is attained.

Rotate the support so that the pads contact the frame squarely when the arms are closed against the racquet. Reverse the clamping procedure to unlock the string clamp. The locking lever is spring loaded to assist the unlocking of the clamp base.

If the string slips through the gripper jaws while pulling tension, rotate the gripper jaw adjustment screw counter-clockwise. If the string is damaged while pulling ten- sion, rotate the gripper jaw adjustment screw clockwise. Pull the string perpendicular to the gripper plates while slowly rotating the tensioner crank clockwise until the brake lever pops out of the latching block.

Rotate the lever down to lock the turntable and up to release the turntable. Place the string on one end of a tension calibrator into a string clamp and secure. Place string located on the other end of the calibrator into the string tensioner and apply tension. Note: The tensioner cover does not need to be removed for the adjustment.

The cover has been removed in the pictures for illustra- tion purposes. To adjust the gap clamping pressure between the clamp jaws, insert the string through the racquet as if you were beginning the main strings.

Print page 1 Print document 20 pages. Rename the bookmark.